The first section of wiring and components to check is the wiring through the ignition switch. 1. Turn off the ignition key to isolate this section. 2. Set your multimeter to measure DC voltage and insert one meter probe in one side of the fuse holder and the other probe in the opposite side of the fuse holder. 3.
Zero Turn Mower / Z 246. 967 665401-00. Please read the operator manual carefully and make sure . you understand the instructions before using the machine. Gasoline containing a maximum of 10% ethanol (E10) is acceptable for use in this machine. The use of gasoline with more than 10% ethanol (E10) will void the product warranty. EN Raise the mower on lengths of 2" x 4" placed edgewise under the cutting deck from front to rear (see diagram). Page 41 Using a 9/16" socket on the bolt of the idler pulley, loosen the deck belt. Roll the belt off the deck pulleys. Roll the belt off the clutch pulley on the crankshaft. Remove the old belt. NOTE: Fluid change for the Swedish Riders needs to be performed by a Husqvarna Service Provider due to the complexities of the drive system. Below are the common models that require drive fluid changes as part of the listed maintenance schedule. EZ, MZ, and earlier ZTH commercial zero turn mowers use 20w-50 non-synthetic engine oil.